dwcraig1
-
Posts
2,322 -
Joined
-
Last visited
-
Days Won
146
Content Type
Profiles
Forums
Downloads
Posts posted by dwcraig1
-
-
If the firmware is the US version that is the problem. Restore to default as last resort and only after you saved your original configuration.
-
Proceed with caution
-
-
Oh, I seemed to have overlooked this, make sure that you are using the International firmware.
In the bottom right lower corner of Device Monitor will show the current firmware that's being used.
-
Perhaps save your current configuration.
Under File/Save As
-
Look at the settings in EScribe
-
For starters make sure that you uploaded settings to device.
Make sure that you are using the desired profile.
Use EScribe's Devise Monitor to check wattage output when firing.
-
Color screens available here: https://www.stealthvape.co.uk/product/dna-75c-250c-screen-replacement/
-
I don't have a small screen 60 but I did plug in my big screen 60 to see if it would offer the update and it did not.
Ask Evolv here: https://helpdesk.evolvapor.com/index.php?a=add&category=1
-
1
-
-
I'm only seeing 1_2_SP6_1 INT as the latest on my PC for either large or small screen DNA60.
-
1
-
-
48 minutes ago, vape vape said:
I get this screen and can't operate at all. What is this screen?
I assume that's a DNA40. Its the serial number of the board.
-
1
-
-
With 2 cells the output of a DNA200 board is limited to 6 volts, 9 volts with 3 cells.
-
2
-
-
If I was making something of that nature I would put a couple 21700's wired in parallel inside a box with a small charger.
-
1
-
-
I use an old cartomizer with it's positive pin soldered to the threaded part. That could also be done with a 510 to 510 adapter.
Setting it to 0.004 ohms would most likely put closer to what it would read. Most likely when shipped it was set to zero.
-
I think he wants the one where Replay didn't work for you in Replay profile.
-
I see no reason why it shouldn't work. Though I am confused with your theme settings/display.
-
1
-
-
Save yours first
-
Yes but you are in 316L profile, that's fine if that's what you want.
I thought you wanted to use the "Replay" profile.
-
-
Look at the profile that I posted, that is correct for using Replay with any/all TC wire when not using Replay with Temperature Control at the same time.
Your Replay profile should look just like that except for warmth settings and boost
-
Here is my Replay profile. I am using dual SS316 Clapton coils.
-
With your theme it will look different. After your puff is it asking to "Save Puff" ?
-
1
-
-
When using Replay profile "Watts" is the material to select but you must use TC capable wire for the coil.
In the TC profiles Replay can also be selected, in those profiles you select the material that you are actually using.
-
1
-
-
If you see the resistance change in EScribe and Replay is activated on the profile and theme if needed and Replay still doesn't work then with a cold atty measure the cold resistance and try again.
-
1
-
1_2_SP6_2_INT DNA60 Small screen
in General Discussion
Posted
I would think that the reason that it's not in the latest EScribe is because an update wasn't needed. I can't think of anything that needs fix'n