No Temperature Reading

[iambyrdman]

I'm getting No Temperature Reading  on a Peranormal 250C.  Tried restoring defaults.  I'm using 316L with this file ~SS316L~.csv .

 

Any thoughts?  Here's Device Monitor showing 3 puffs

 

Edited August 12, 2018 by iambyrdman

[iambyrdman]

This is a device I built so I think I know how it works...

[iambyrdman]

I'm just having a bad luck run.

Now this one I built isn't cutting off when it hits temperature...

[retird]

I wonder if it could be the atty, coill,  or a wiring issue....  If I recall when you built #2 it wouldn't read TC either....

[Wayneo]

Can ya describe your coil.

[iambyrdman]

I'm using SS316L.  I usually build coils where I'll spin more than one wire together but I have found them to be less stable.  However I get the same results out of simple round wire builds.

 

At this point I'm wondering if I'm getting bad wire maybe.  I should break out an out Uwell Crown and see if that changes anything.  It's approved for Replay is why I'm thinking that.

[Wayneo]

Alrighty, can you do one last printscreen while taking a puff. Using the mod in that last Printscreen (ByrdBuild#2). Same atty and coil used there. Using your Profile 7 like in the PS, but ONLY with these checkboxes ticked.

 

[iambyrdman]

3 hours ago, Wayneo said:

Alrighty, can you do one last printscreen while taking a puff. Using the mod in that last Printscreen (ByrdBuild#2). Same atty and coil used there. Using your Profile 7 like in the PS, but ONLY with these checkboxes ticked.

Seems even more out of hand than last try.  Why isn't it stopping at set temperature?

[Wayneo]

Can ya do a full printscreen of your Profile 7