stop asking about new resistance

[JaI Haze]

I cannot find the setting to stop this from asking.  Everytime it goes into standby mode, when I fire it up it asks for new resistance.  I tried ohm lock range at 50% and 25% to no avail. Where is the setting to disable this every single time

[ajoe]

I have two DNA250c devices from two different manufacturers, both are running the default Evolve theme.

I have never seen this behavior. 

Do you have a custom theme installed? If so, perhaps reverting to the default theme would help.

I checked the Escribe docs and can't find any settings to control such behavior.

Sorry I can't be of more help. Maybe someone else has run into this.

[JaI Haze]

37 minutes ago, ajoe said:

I have two DNA250c devices from two different manufacturers, both are running the default Evolve theme.

I have never seen this behavior. 

Do you have a custom theme installed? If so, perhaps reverting to the default theme would help.

I checked the Escribe docs and can't find any settings to control such behavior.

Sorry I can't be of more help. Maybe someone else has run into this.

the problem is this happens even on default themes.  It basically asks for resistance every time it goes into standby mode and I fire it

[Wayneo]

@JaI Haze You never the mentioned the mod or atty, or just one of either. Or if it's any mode, TC only, Replay with TC, etc. I'd check your build, 510 on both mod/atty and your ground connection. Cheers meng.