change max temp from 600º to 950º for enail.

[Jay@ADV]

i have changed my max temp from 600º to 950º so i could use it for another purpose however it still wont fire past 600º even tho i changed it to 950º 
any idea how to make this actually work ?

 

 

[Chris Musampa]

I can confirm the same.  I was thinking about temp limiting for cleaning SS coils a while back (more for interest than necessity) so I raised the limit to 400°C, I could now set 400C on the mod but it would still stop at 315C anyway.

 

[Wayneo]

Steam-engine. Wire Wizard. Upper right hand box. You'll see equivalents. Use Nickel. In the lower area of the page, use your actual material. Also it's a good way to use different materials on the DNA40 which only had Nickel.

 

 

[Chris Musampa]

23 hours ago, Wayneo said:

Steam-engine. Wire Wizard. Upper right hand box. You'll see equivalents. Use Nickel. In the lower area of the page, use your actual material. Also it's a good way to use different materials on the DNA40 which only had Nickel.

I think I ended up adjusting a graph from some other wire, can't remember.  Would've been less hassle if the increased temp limit actually worked though, it seems bugged.

 

Edited November 21, 2018 by Chris Musampa