Alternate usb pins on charging board

[georgii_]

I want to solder type c connector to latest evolv charger bypassing stock micro usb (lostvape epetite mod), and I found 4 pins under micro usb connector. If this pins are mirrored microusb connector pins (there is NO datasheat for charger)?

 

[Wayneo]

That doesn't look like an Evolv 1A data/charging board to me. Mine shows 'Evolv' on the other side.

[retird]

 

[georgii_]

Thanx for reply. So I measured V on this pins and they shows about 3.1-3.2V under load, meanwhile pins on micro usb shows about 4.5V so it's not possible to do this way. The only thing is left - solder to pins of micro usb :(

[retird]

https://www.amazon.com/ARKTEK-Adapter-Charging-Digital-Samsung/dp/B072J5B3BR/ref=sr_1_5?ie=UTF8&qid=1528976874&sr=8-5&keywords=usb+c+to+micro+usb

 

[Spector NS5 RD]

@georgii_ your easiest option is to go with what @retird posted.

The other option would be to use something along the lines of this : https://www.ebay.com/itm/DIY-24pin-USB-Type-C-Male-Female-Plug-Socket-Connector-SMT-Type-w-PCB-1-Set-/311630199174   

You would have to tap into the USB +5v, GND, Data + and Data - traces on the charger PCB. Lost Vape rolled their own 2 amp charging board, they didn't use the Evolv version. You would also have to make room for the USB C breakout board and widen the USB socket hole for the larger C socket. A lot of work for little to no gain, IMO. Why do you want a USB C connector instead of the micro USB?