Reading ohms too high therion bf 75c dna

[Scott111]

Hi. I'm hoping someone can point me in the right direction.   My builds will read .5 on all my other devices, including older dna74 devices, but on my new therion with dna75c, I'm getting a reading as far off as .9  

tried multiple attys and builds   

I have escribe but have no idea if this is something I can fix via escribe

any suggestions would be appreciated 

i only run in wattage mode   I dont us TC

Thanks 

thanks

 

[retird]

So, I guess,, your older DNA 75 devices are sponkers also ?  Can you post a screenshot from EScribe showing the Electrical and Thermal settings of the 75C.  This info is found in the Mod Tab of EScribe.

[Scott111]

Sponkers? If your mean squonkers, no. One is a rebel mod and the other a JAC Vapours series B.  I'll post the numbers tomorrow 

[retird]

Oops... sorry for the misspelling of squonkers..... so you only are comparing the 75C (squonker) to non-squonker devices but all devices have DNA boards....

From another 75C thread I found this....

"Is the resistance consistently wrong in Atomizer Analyzer? If so, definitely make sure your case grounding is good (are the grounding screws loose?).

The measurements used to sample Ohms (for Atomizer Analyzer or New Coil) are done at very low power (otherwise the atomizer would heat up while measuring, which would ruin the measurement), so grounding issues can be more significant than at full power. This is true for other DNAs as well, incidentally."

[Scott111]

Not comparing it to other squonkers.  This is the only regulated squonker I have.  Other devices are dna75 or provari radius or dotmod and my coilmaster tab ohm reader

 

 

[Wayneo]

18 hours ago, retird said:

... post a screenshot from EScribe showing the Electrical and Thermal settings of the 75C.  This info is found in the Mod Tab of EScribe.

And what's the coil wire type?

[Scott111]

Kanthal 24 gauge 

 

didn't have a chance to hook it up to escribe yet 

Edited September 25, 2017 by Scott111

[Scott111]

The mod stopped working today so I'll be sending it back for refund.   Won't fire and just keeps reverting to welcome screen 

[Scott111]

Strange.  Cleaned the 510 on mod and now it fires and operates normally.   Problems started right after refilling with the refill bottle through the 510.  Will give it a few days before returning I guess

still not sure about my ohm issue but I'll deal with that after I decide what to do