eucalyptus. Posted May 28, 2017 Report Share Posted May 28, 2017 Hello. My DNA 75C is "short" when remove the atomizer. After resetting, it becomes "CHECK ATOMIZER" before attaching the atomizer. I examined it with ATOMIZER ANALYZER, after removing the atomizer, the value of 100 ohms or more appears. My MOD is actually not short-circuited. Is there a problem with my board? . Revision:20 Theme:Default Theme. ( "Factory Setting Reset." ) Link to comment Share on other sites More sharing options...
retird Posted May 28, 2017 Report Share Posted May 28, 2017 Have you checked the ohm's at the connector with an ohm meter using the same "off/on " process? 1 Link to comment Share on other sites More sharing options...
retird Posted May 28, 2017 Report Share Posted May 28, 2017 Also, have you tried another atomiser as some atomizers have longer or shorter 510 pins and devices have different 510 connectors so it could be a conectivity thing....... 1 Link to comment Share on other sites More sharing options...
eucalyptus. Posted May 28, 2017 Author Report Share Posted May 28, 2017 Thank you for your reply. 510 The connector is removed once it is confirmed. Resistance value between ATM and GND is about 500 ohms when the board is not connected and nothing is connected. Since this value is almost equal to normal DNA 75, it is judged that it is not physically short-circuited. Link to comment Share on other sites More sharing options...
John Posted May 28, 2017 Report Share Posted May 28, 2017 More likely to be a minor bug in the software (there are two hardware comparators, one looking at over-the-counter and one looking at over-current) The hardware of the DNA 75C is fairly similar to the regular 75, except for all the added components for puff recording and timing and running the screen and storing the configurable UI etc. But the software is a completely new codebase. It's probably just interpreting or displaying the error state wrong. We'll add that to the list of small bugs to clean up, but I wouldn't worry about it too much. Link to comment Share on other sites More sharing options...
eucalyptus. Posted May 29, 2017 Author Report Share Posted May 29, 2017 Hello. Thanks,for reply!. When a short circuit is detected, it forcibly shuts off and a click sound is emitted from the board. Since it seems to be a malfunction at first glance, I expect it to heal. However, because it is not a fatal factor, priority is low and it is OK. Link to comment Share on other sites More sharing options...
John Posted June 2, 2017 Report Share Posted June 2, 2017 We were able to replicate and correct this, the fix will be in the next service pack. Link to comment Share on other sites More sharing options...
eucalyptus. Posted June 3, 2017 Author Report Share Posted June 3, 2017 Thanks for Implementation!. Link to comment Share on other sites More sharing options...
James Posted June 6, 2017 Report Share Posted June 6, 2017 Hello @eucalyptus.! This has been fixed in the newest Service Pack. Link to comment Share on other sites More sharing options...
eucalyptus. Posted June 7, 2017 Author Report Share Posted June 7, 2017 Thank you very much. I will check it immediately. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now