Room temp

[Xx3dge]

Is it normal that my room temp is 8°f higher then my actual thermometer I have in my room? I'm going by the live readings on escribe.

[mikepetro]

I am interested in the response to this. I have 10 degrees higher even after running case analyzer.

[VapingBad]

And me, ran case analyser 3 times and still about 10 F high.

[scoopy]

Interesting. .. After running case analyser twice on my mod I'm getting like 6-8 degrees lower than actual room temp

[dwcraig1]

Mine has been sitting for a couple of hours unused with no usb attached, read the thermometer on wall near it, mod says 87.25F and thermometer reads 88.
Thermometer is about 3 feet higher. I'll check it again after it's been connected with usb for a whileand see if there's a difference.
And a little later with usb plugged in and charging, board room temp is 93F, thermometer says 90F 

[retird]

Reference mod sat overnight to reach room temp. Started EScribe, plugged in reference mod (holding mod by the tank so as not to raise the device enclosure temp). Immediately clicked Device Monitor and read room temp.  Digital Room Thermometer setting next to reference mod read 69.70 F and Device Monitor showed room temp. at 69.52 F.

[Xx3dge]

So should I run the case analysis when the device has been sitting overnight? Is the values I'm using wrong since I was handling the device before starting case analyzer?