MaxMorozoff Posted March 25, 2016 Author Report Share Posted March 25, 2016 Hi everyone. Old lipo has damadged, so i changed lipo. Now it shows 0 volts, but multimeter shows 3,61 on each cell. When i click fire button it shows error "Check Battery".What can i make with it? _______________________________________________________P.S.: I'm new to DNA forum, so forgive me, if I broke some rules.P.P.S.: There's no warranty on this device. Link to comment Share on other sites More sharing options...
VapingBad Posted March 26, 2016 Report Share Posted March 26, 2016 It is not showing the battery icon either, check it is not set to power supply as battery type in Escribe, I don't if a blow fuse would cause that. Link to comment Share on other sites More sharing options...
MaxMorozoff Posted March 26, 2016 Author Report Share Posted March 26, 2016 Battery type is set to "Lithium Polymer".I've tested a fuse with multimeter, and there is a contact. Or it isn't right way to check the fuse? Link to comment Share on other sites More sharing options...
dwcraig1 Posted March 26, 2016 Report Share Posted March 26, 2016 In your 1st post it shows it powered on with the battery, I don't think it would be able to do that with a bad fuse.Does your battery have plugs or did you have to solder the wires to the board?Are you sure that the first battery was bad? What was the problem do you think with the first battery?I'm hoping to get some more info posted on it so when the folks more experience than me come on maybe they will have something to add. Link to comment Share on other sites More sharing options...
MaxMorozoff Posted March 26, 2016 Author Report Share Posted March 26, 2016 dwcraig1 said:In your 1st post it shows it powered on with the battery, I don't think it would be able to do that with a bad fuse.Does your battery have plugs or did you have to solder the wires to the board?Are you sure that the first battery was bad? What was the problem do you think with the first battery?I'm hoping to get some more info posted on it so when the folks more experience than me come on maybe they will have something to add. I have to solder the wires. First battery was inflated and wires isolation was almost burn and red cable (V+) was close to metal case (GND). Also one cell was dead (0 volt). There was some noise on the screen and i thought the reason was bad power. ________ Hope you understand my English... Link to comment Share on other sites More sharing options...
dwcraig1 Posted March 26, 2016 Report Share Posted March 26, 2016 Can you put up a picture of the bottom of the board where the wires attach? Link to comment Share on other sites More sharing options...
MaxMorozoff Posted March 27, 2016 Author Report Share Posted March 27, 2016 dwcraig1 said:Can you put up a picture of the bottom of the board where the wires attach? I've already cut it off. I plugged DNA to 60w power supply and it works. Probably the problem is charge controller which is above the USB. TI BQ76925 Link to comment Share on other sites More sharing options...
black lace Posted March 27, 2016 Report Share Posted March 27, 2016 too late now by the sound of it, JST leads mixed up?????sorry to undermine if that's what you where looking for dwcraig1.. Link to comment Share on other sites More sharing options...
dwcraig1 Posted March 27, 2016 Report Share Posted March 27, 2016 I was thinking that might be a good possibility. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now