Efusion Duo different cells volts

[buggah]

Hello, this is a big problem or nothing really bad? Actually I was looking problem with battery percentage, it is jumping like a crazy, one time 39%, after 1 hour (sleep mode, not vaping) 50% . 
 

[buggah]

now it seems okay, but what happens with battery percentage? 3.71 V and 0% haha 
 

[Wayneo]

I take it that you have the Lipo installed?

[buggah]

yes guys, it is stock lipo 1300 mAh as I remember

[VapingBad]

What are your battery watt hours and soft cut-off settings?

Also have a look in device monitor to see if one or more cells is sagging excessively when firing.

[Modbustersecig]

 i posted this before is num cell 3 looking bad week ? it gets further off as the pack voltage goes down i razed soft cell cut off to 3.09 and still dose not seem right at cell voltage at 3.10 and below it well not even hit 290 D F coil and no message check battery    i am trying to figure out soft cell cut off problem or just poor battery pack thanks for looking  DNA250

[buggah]

VapingBad it is 1300, 14.43 Wh, cutoff is 3.20.

 

today I got check battery when I tried to burn fire single coil (only at 12w) connected device to escribe and I saw my Cell 3 is 3.40 V (as I remember) and cell 2, 1 was 3.21 V. Device is really new, charged maximum 20 times.

[VapingBad]

3.2 V is very high, it will cause battery warnings when any 1 cell reaches that under load, for LiPos the default is 3.09 and you can go below 3 with 18650s.  It may also be that cell 3 is weaker than the others.

[buggah]

okay will make 3.09, yesterday I had this problem      but after few minutes my it was okay    , maybe I had to try full charge it? when I saw it is same Volts I just removed the usb. what I have to do now? By the way, percentages is jumping again

I dont know it is battery problem or something wrong with my escribe. Tried reset it.