Ewolf Posted January 24, 2020 Report Posted January 24, 2020 Hallo Ich habe seit 2 Tagen einen DNA200C. Die Replay-Einstellung/Aktivierung habe ich gefunden. Benutze 2 Wotofo Verdampfer mit original Wotofo-Mesh zusammen mit dem Paranormal250C accuträger. Der eine Verdampfer speichert die Replay-Werte, der andere nicht, zeigt nicht die Speicherfunktion. Auch nicht nach wechseln des Siebes. Was kann ich tun? Grüße aus München
Ewolf Posted January 24, 2020 Author Report Posted January 24, 2020 Clearomizer 1 do it, clearomizer 2 no do it. ??? Is the simular clearomizer!
dwcraig1 Posted January 24, 2020 Report Posted January 24, 2020 The coil material must be capable of being used in temperature mode, Kanthal and Nichrome will not change resistance when heated. Check in Escribes Device Monitor to see if resistance changes from cold to hot.
Ewolf Posted January 25, 2020 Author Report Posted January 25, 2020 Coil (red) save the settings... Coil (blue) save not the settings...
dwcraig1 Posted January 25, 2020 Report Posted January 25, 2020 What I see is the coil material isn't changing resistance when heated. It might be Kanthal or Nichrome and that is not TC capable. Sometimes due to poor connections between the board and coil there is enough resistance change to trigger the Save Puff, but this is pretty much by accident and not by design. Try using Stainless Steel mesh/wire.
Wayneo Posted January 25, 2020 Report Posted January 25, 2020 What is the coil material? I see both coils actually dropping resistance when firing by a couple mΩ's. And you can use a sniping tool for decent printscreen. 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now