blueridgedog Posted May 31, 2019 Report Share Posted May 31, 2019 I am building up a ABM-1 enclosure and they supply a try for a 20700 that joins the battery negative to the case metal/atomizer. See: http://analogboxmods.ca/image/cache/catalog/parts/battery_holders/20700/ABM1-1x20700-2-800x700.jpg So, I will still run a negative from the battery to the chip for charging, but two questions: Will this work? I have never run battery negative to the case before Do I need to also wire it to the chip output end ground? I think not since the case is metal and the ground path would then be the screws. Thanks for your input. Not clear on why the battery negative is run to the case. Link to comment Share on other sites More sharing options...
dwcraig1 Posted June 1, 2019 Report Share Posted June 1, 2019 Output Gnd and Batt- are internally connected within the board, my opinion is that it will work just fine with or without the Batt negative wire from sled to board. Yes the output ground will need to be attached to the 510 ground. 1 Link to comment Share on other sites More sharing options...
blueridgedog Posted June 1, 2019 Author Report Share Posted June 1, 2019 Thanks. Been a while since I put one together...been buying LostVape gear but they have imploded and I can't find a decent mod with an evolve chip for love nor money. Link to comment Share on other sites More sharing options...
dwcraig1 Posted June 1, 2019 Report Share Posted June 1, 2019 That same sled setup would also work well with a printed case. BTW, that's a nice looking box. Link to comment Share on other sites More sharing options...
blueridgedog Posted June 1, 2019 Author Report Share Posted June 1, 2019 Small! Link to comment Share on other sites More sharing options...
blueridgedog Posted June 2, 2019 Author Report Share Posted June 2, 2019 Made a nice smallish mod. Going to put a 250 in one with a 3 cell lipo. 1 Link to comment Share on other sites More sharing options...
dwcraig1 Posted June 2, 2019 Report Share Posted June 2, 2019 A DNA75C with it's up to 100 watt boost (INT firmware) and a 21700 is a pretty capable device. That's a nice one. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now