exisspl Posted November 1, 2015 Author Report Share Posted November 1, 2015 Hello everyone,I just received my Evolv DNA 200 on Thursday and straight out of the box I run into an issue of ''check battery'' error. As someone suggested on this forum I downloaded escribe, updated software and did a recovery charge. That worked fine. However after a day of use and battery running flat I noticed that I cannot charge it via anything else other than USB connected to my laptop with escribe running. When I connect it to mains, it seems that it charges only when the screen is on (the screen shows it's charging however I left it for 3 hours plugged in with no luck).I am a DNA newbie and this is my first 'proper' mod (was using iStick 30W and 40W TC previously) so I am quite overwhelmed with all the functions of escribe software. I wanted to find out if I need to return it or is there something that can be done? Any help would be appreciated. Link to comment Share on other sites More sharing options...
Sirvape Posted November 1, 2015 Report Share Posted November 1, 2015 HiIf you like you could take out the battery and get it tested on a RC chargerthis charger can tell you if the battery is malfunc.then again i know the mod is new, its your call Link to comment Share on other sites More sharing options...
awsum140 Posted November 2, 2015 Report Share Posted November 2, 2015 I suspect you are being "fooled", as was I. Check the screen tab in eScribe with the DNA connected. You'll see a selection for screen brightness when charging. The default setting is 0%, black screen. Set it to, say, 50%, and give it a shot. You'll see your DNA charging from the wall wart. Link to comment Share on other sites More sharing options...
VapingBad Posted November 2, 2015 Report Share Posted November 2, 2015 As Awsun140 said, also if you put USB current in one one the optional fields for the charging screen it enables you to select a charger & cable combination that supplies 1 A (probably 997/998 mA) as many don't. Link to comment Share on other sites More sharing options...
exisspl Posted November 2, 2015 Author Report Share Posted November 2, 2015 awsum140 said:I suspect you are being "fooled", as was I. Check the screen tab in eScribe with the DNA connected. You'll see a selection for screen brightness when charging. The default setting is 0%, black screen. Set it to, say, 50%, and give it a shot. You'll see your DNA charging from the wall wart.This worked, thank you! Maybe the mod would go into sleep mode or turn off after the screen is off making it not wanting to charge or something. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now