Thatguy Posted January 11, 2016 Author Report Share Posted January 11, 2016 Im trying to love this board, I think I just need a tiny help, I appreciate it very much. I have a maxamps 1800mah 2s running to the b+ and b- tabs and a positive to the atty (plastic box) from the out tab and ground to the tab in the top of the board right next to it, that says gnd. When I fire it up it reads ok, won't fire says check battery. The inky thing I changed in escribe is the box that says lipo and 2 cells. I changed it to power supply, upload settings and its working, but that's not how it should be, I know. Is there something I need to upload firmware, etc, any help will be greatly appreciated. I think it's just something simple, I'm loving it but I'm not gonna keep running it in power supply mode. Link to comment Share on other sites More sharing options...
sotirisba1 Posted January 11, 2016 Report Share Posted January 11, 2016 Check thesehttps://forum.evolvapor.com/topic/66226-topic/https://forum.evolvapor.com/topic/67232-topic/?do=findComment&comment=905179 Link to comment Share on other sites More sharing options...
Thatguy Posted January 11, 2016 Author Report Share Posted January 11, 2016 Thanks I looked thru most of those already, I built a mod that runs on 2 series 18650s I ran that in power supply mode, but this is a lipo, typical setup, I want to avoid using the connector if possible,I want to use that for a charger later but I want to get it setup running a 2s lipo right first. ?? Link to comment Share on other sites More sharing options...
VapingBad Posted January 11, 2016 Report Share Posted January 11, 2016 I think you will have to connect the balance wires, bridge the 2 highest pins (2 & 3) and set it to 2S because Power Supply will expect 9-12 V and a 2S will not give that. Link to comment Share on other sites More sharing options...
Thatguy Posted January 11, 2016 Author Report Share Posted January 11, 2016 So Just Bridging those wires will allow it to work with a 2s lipo ? besides changing the box from 3cells to 2 cells in escribe is there anything I nee dto change or upload to the device? Willl I be able to charge it thru the micro usb port? I would like to add a jst for 3a to each cell charging as well, but I need to get this fixed first. Thanks for the help. Link to comment Share on other sites More sharing options...
VapingBad Posted January 11, 2016 Report Share Posted January 11, 2016 Bridge the 2 pins AND change to 2 cell battery in EScribe, then it will do everything except go above 133 W, I would also check the what hours value you can use the calculator with 7.4 V as the battery voltage. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now