TheMadKracker Posted January 13, 2016 Author Report Share Posted January 13, 2016 I have a DNA200 that I built. Been using it for around 8 weeks now. I run it at around 25W, with temp builds, almost exclusively. I have the board configured for the case, battery and internal resistance. Running a 12oo mAh Kinexsis Lipo.I was vaping on it at work. Took a drag, exhaled. Took another drag, nothing happened. Looked at the screen...its blank. Plugged it into Escrib...would not connect. I am using the same USB cable that I configure all my mods with. Opened up the mod and checked the Lipo pack with a DMM, reading 11.55V. Checked the fuse with a DMM and it is good. For S&Gs, I checke my grounds and checked for shorts, all with a DMM.This board literally just stopped working. The only thing I have done to the board recently was add the Ti profile for Sweet Spot Ti 0.4mm wire. I did that 3 days before the board died. Link to comment Share on other sites More sharing options...
Spector NS5 RD Posted January 13, 2016 Report Share Posted January 13, 2016 even tho it says it's not connected to escribe, try to force a firmware update. worth a shot. since your board is only 8 weeks old, it's still under warranty. open a ticket with evolv, and RMA the board. Link to comment Share on other sites More sharing options...
TheMadKracker Posted January 14, 2016 Author Report Share Posted January 14, 2016 Thanks for the advice. I tried just tried that and it kept giving me the "no USB device detected " error. I tested the cable and the rest of my devices recognize.. Link to comment Share on other sites More sharing options...
Spector NS5 RD Posted January 14, 2016 Report Share Posted January 14, 2016 you're not the first person to describe this failure. best bet is to RMA the board asap to get u back to Link to comment Share on other sites More sharing options...
digatel Posted January 14, 2016 Report Share Posted January 14, 2016 Like ChunkyButt said, try forcing a firmware update or try rebooting your computer with your mod hooked up to it to try and reboot it. If neither of those work, then open a ticket with Evolv through their homepage. I say it all the time, that Evolv has impeccable customer service. So, don't fret, your issue will be resolved. Good luck and keep us updated! Link to comment Share on other sites More sharing options...
TheMadKracker Posted January 15, 2016 Author Report Share Posted January 15, 2016 So now I have 3 dead devices. Second device started giving me the "Warranty" error last night. Went through the same troubleshooting I went through with the first one. No issues found. Decided to replace the board in the first device with a new board I have in hand. Got it wired and installed. Hooked it up to Escribe to update the board. My computer started updating drivers for it right after I plugged it in. screen went black and will not turn on now. It will not recognize or connect to Escribe. FML, 3 device dead in less than a week. Link to comment Share on other sites More sharing options...
blueridgedog Posted January 20, 2016 Report Share Posted January 20, 2016 Though you are going to RMA it, did you check the fuse? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now