Jump to content

Using Wh output from battery analyzer -- showing 100% charge at 12.3-4v


justchil

Recommended Posts

I am curious if anyone else notices this....  

I ran battery analyzer several times with long cooldowns in between.  Every time I run it I get about -1Wh from what the battery is rated for (Maxamps 1850).

I will see 100% charge when the pack voltage is 12.3-4.  

I changed the WH using the calculator and the battery % goes down to ~94% which seems right.  I will run analyzer again... this specific mod has around 1months use on it.  

Link to comment
Share on other sites

justchil said:

I am curious if anyone else notices this....  

I ran battery analyzer several times with long cooldowns in between.  Every time I run it I get about -1Wh from what the battery is rated for (Maxamps 1850).

I will see 100% charge when the pack voltage is 12.3-4.  

I changed the WH using the calculator and the battery % goes down to ~94% which seems right.  I will run analyzer again... this specific mod has around 1months use on it.  

when you change the watt hours to show 94% does it charge to 100% when you plug it back in to charge? when some of my dna 200's stop charging at the 96% or i'll either unplug and plug it back in to get it to charge the final percent or i'll take a vape while it's plugged in and it'll restart itself after a few seconds. i think it doesn't fully charge to 100% sometimes because the watt hours are slightly off, even after running batt analyzer. you can knock it down a few watt hours to it to charge all the way or do my suggestions.
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...