Tshort Posted May 30, 2016 Author Report Share Posted May 30, 2016 Yesterday I noticed my mod was only charging at 0.3 amps. Now each cell is reading fully charged on the mod (4.20) and my batt percentage is only 86%. Never had any problems with it and it would read 97%-100% when the cells were fully charged in the past. Have not messed with any settings or anything. Any help would be appreciated. Thanks Link to comment Share on other sites More sharing options...
BillW50 Posted May 30, 2016 Report Share Posted May 30, 2016 The charging current will drop when it gets close to a full charge. Also the DNA200 will not draw more current from the USB than it can safely supply.The battery percentage is based on the configuration of the battery capacity. As cells age, they lose a bit of capacity. So you might have to drop the watt hours in EScribe's Mod (tab) with time. Link to comment Share on other sites More sharing options...
Tshort Posted May 30, 2016 Author Report Share Posted May 30, 2016 It's just hard to believe the percentage would be that far off. You would think the percentage would gradually work down instead of going from 100 to 86. Thanks for your help Link to comment Share on other sites More sharing options...
BillW50 Posted May 30, 2016 Report Share Posted May 30, 2016 If all of the cells are 4.20v after charging (or 4.10v, depending on your settings), the DNA200 is operating like it should. And the battery capacity is measured by actual watt hours used. Link to comment Share on other sites More sharing options...
retird Posted May 30, 2016 Report Share Posted May 30, 2016 Which device do you have? Link to comment Share on other sites More sharing options...
Tshort Posted May 30, 2016 Author Report Share Posted May 30, 2016 Axis m17 Link to comment Share on other sites More sharing options...
retird Posted May 30, 2016 Report Share Posted May 30, 2016 Their web page spec's say the battery is 12.21 watt hours (1100 mah). What are the settings showing in EScribe under the Battery Section?Nice looking mods by the way....http://axisvapes.com/our-stabilized-wood-mod/ Link to comment Share on other sites More sharing options...
Tshort Posted May 30, 2016 Author Report Share Posted May 30, 2016 Exactly that. They are already pre set. I double checked to make sure. I have only had it a little over a month Link to comment Share on other sites More sharing options...
retird Posted May 30, 2016 Report Share Posted May 30, 2016 If you don't have a problem changing the watt hours to something like 11.1 and uploading it to see how it reacts you might see a difference in the battery meter at full charge. You can always change it back to 12.21. The watt hours setting effects the battery meter in the device but not the charging to a full 4.20 volts of each cell. Link to comment Share on other sites More sharing options...
mikepetro Posted May 30, 2016 Report Share Posted May 30, 2016 If all else fails, and you are concerned about the accuracy, run the Battery Analyzer on your mod. It will be dead nuts on the money after that.Its not uncommon for mass produced Lipos to vary in capacity, even within the same lot. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now