Jump to content

Custom TCR


GreekNick

Recommended Posts

The 2nd screen shot is not 0.006, I know the line shows 0.006 when the edit box is open, but if you cancel it reverts back to what is in that memory slot.   Did you change the value to something other than 0.006 and save or if you just cancelled then the TCR on the mod wasn't 0.006.

Link to comment
Share on other sites

I'll give it a go.

If EScribe is just opened and you put up the window to change the TCR of a particular material it will have .006 in the box by defaualt as well as show you the graph for that setting. Nothing is changed till you press"OK".
If EScribe wasn't been closed and you have changed the TCR of a material then it will show that number in the box by defaualt.
Again nothing is changed till you "OK" it

Link to comment
Share on other sites

GreekNick said:

Yes but why it is changing it to all other matirials


I don't think it is, as I said when you open the box to enter a TCR it defaults to 0.006, but this is not the value that is currently stored you need to compare the curves.  Because the profiles are not a single ratio TCR they cannot convert most of them to a TCR without loosing data so they don't try, this can be confusing I know, but it is what it is.   FWIW may values have never changed on the 2 DNA 75s I have.
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...