bdaines

Do you anneal your wire or torch it? I've noticed as I've "cleaned" the coil multiple times the temp control may have become more accurate. I've gone from around 420F being a good vape to 405F. Granted, I have inadvertantly switched to a PG heavy liquid (not my usual preference) so that's probably a contributing factor as well, but the amount of heat I'm getting seems to be comparable.

I can't seem to find documentation on the process for properly measuring and profiling materials for TC. Does this documentation exist anywhere? Seems like something that would have been worth publishing....

The stealth vape curve seems to be working pretty well with the 425 setting. Just ran out of liquid and did not get burnt hit. Which is really all I care about. I may pick up some stealth vape wire just for kicks, but I can't really say that's strictly necessary. Thanks for taking the time.

Definitely closer, that's got me around 425F down from 485F

Awesome. I will give that a try and report back. Just to confirm that's for the z48 correct?

I guess it would be nice if someone could create an updated curve so that it reads correctly. Unfortunately it seems like there is not much interest and that kind of thing anymore.

Connections are tight, and does seem to read cold ohms pretty close (.25 vs .23). Even tried the .00400 that zivipf lists as the TCR. Wicking well too. It's not kicking out of TC mode either, I just have to have it cranked way up to get anything decent out of it. Currently at 485F. I even gave the screws & holes a good cleaning before putting the build in.

Just got this stuff in, running the stream engine NiFE52 profile as folks on the forum have instructed and it barely vapes cranked up to 450F. What gives?

For some reason my Vapedroid (DNA75) doesn't display the charge current on the charging screen. I've had other DNA devices that I've configured the same way as I have this one configured, all of which do properly display the USB charge current. This one just doesn't. Ideas? It seems like such a simple thing, but it's really nice knowing the current charge current.

I have noticed that the TC has gotten more stable as the coil "breaks in" Can you link me to that post on preparing the SS? Thanks.

Some findings to report: Ran all my analyzers, shorted the 510 as best as could with what materials I had (some stranded silver wire balled up and jammed in the 510, used lowest resistance measured). After all that, I've achieved basically the same behavior as the Dicodes reference. This concludes another noob post. Here are the results. Mod: MarkBugs Amulet DNA75 Eliquid: 80% VG Atty: Gem 2 (not-really-cloud-bro rta) Coil: 28g GeekVape 316L, 7 wraps, 2mm ID, 1mm±0.1 spaced wrapps amulet.ecig

Tried 0.005 and I get hardly any vapor now and no warmth at all

What materials are your 510 made from? I've got SS threads and a silver plated positive. I'll give the lower values a try though to test the theory.

Relatively new stabwood box, so I don't think anyone's going to have values to share. It's MarkBugs wood box.

Not really. I need to find a slug. I "tested" it with a screwdriver. So probably wildly inaccurate. Didn't have any value out of the box though.