I’ve been messing with a troublesome Atty that works in TC ok initially then after a refill or when I mess with settings on the mod switches in to a power/watts mode and won’t switch back to TC even though I’m using a TC set profile. I’m using 316L SS wire.
I went in to Escribe after a clean up let it cool down took an Atomiser reading and locked the ohms. It worked for half a tank but I tried to see if I could adjust the Pre-heat which I had zero’d out previously in Escribe.
Well I couldn’t figure out how to adjust pre-heat on the mod for TC, only for Wattage mode, so is that change only possible in Escribe for TC mode.
what can I do to get my mod to switch back to TC when it’s switched over to Power/Watts and won’t switch back?