Jump to content
Evolv DNA Forum

steamer861

Members
 View Profile  See their activity

  • Posts

    91

  • Joined

  • Last visited

  • Days Won

    5

 Content Type 

Posts posted by steamer861

  2. Wismec RX200 to DNA 200 Conversion

    in General Discussion

    Posted

    Is this project even worth anyones time? I could see if you were making some thing unique or some thing thats not readily available  out there.
    These mods are available for purchase with a DNA 200, Why buy the cheep mod, a chip and do all this modding, to save 25 bucks?
    Complete waste of time IMO. Just buy one with a DNA200 :)

  10. How many of you have a dead board?

    in General Discussion

    Posted

    I had one malfunction yesterday. I built this one a little over a week ago.
    It is in a 3D printed box and use's a Gens Ace 1300mAH battery.
    From what I'v read it has a burnt fuse and possibly some other issue that caused it.
    This particular board was doing some thing a little  odd, every once and a while it would power way up and the hit off it would be so hot I could barely  stand it.
    Nothing would change in escribe or on screen but the vape was different .
    Then as mysteriously as it came it would go and the board would seem fine.
    Then yesterday during one of it's mystery power up episodes it stopped working.
    Rite as I was taking a really hot hit.
    At first I connected it to the USB and opened escribe and nothing it was dead.
    So upon further inspection it appeared that the fuse had blown.
    I did a bit of reading and read that if the fuse was blown that escribe
    would still recognize the board.
    I reattached to the USB and open escribe the screen came on but escribe would not recognize it, it had no battery attached at this point.
    I connected the battery back to the mod and plugged it back into the usb, opened
    escribe and the screen came on the board was recognized by escribe.
    I was able to connect and down load settings.At first it pop up an error saying eprom could not be read. But on a second attempt the error went away.
    Everything seemed normal at this point, so I tried to attach an atty while it was still connected to the USB and it would go dead rite away, also as soon as I disconnected the USB it would go dead to.
    Here's a Pic of the fuse it.s a little hard to tell from the pic but the top is blown rite off



    So now I put in an inquire at the Evolv site and am waiting for a reply.
    FYI the one that blew the fuse was running a dual coil TI build at .1
    I was using a custom CSV file from Steam engine site.
    I have another mod exactly the same I put together just a few days ago.
    It is working perfectly for 3 day now running dual NI  200 coils at .08 
    Here'  a pic of the good one 



×
×
  • Create New...