JTree

nvmd. after a half hour of google searching, i posted this, then found it another 60 seconds later

Following in chowderhead's footsteps, I'll be wiring for external charging. I'm envisioning a receptacle port mounted inside the enclosure I can plug a stand alone charger in to for quick charging. Can someone point me to a chart that shows me what the part number for the identical receptacle on the board and the corresponding plug?

I'll consider that....still have to figure something out for the screen, but that would help with sealing up the buttons and usb port. Maybe incorporate some thin plexiglass in the mold or something similar for the screen. Good thoughts in a new direction.

I'm a mechanic, not an electrician, so please humor me while I ask an idiot question as the idea of charging in under 15 min has me extremely interested: So what you are doing is splicing in to the balance connector's wires somewhere along it's length to a second balance connector for fast charging, correct? And the additional current doesn'T hirt the board? If all this is so, please point me to the ecf thread so I can see this, pretty please.

Trying to finish out the parts list for a build. Trying to make the enclosure dust/spill resistant. Trying to find either a) stick on low pro rubber/silicon boots to cover stop peg actuators for the on board up/down buttons or b) appropriately small sealed buttons. Also, any ideas for a way to seal off the screen that won't eat a cubic meter of real estate in the enclosure?