Spirometry
-
Posts
135 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Spirometry
-
-
I have a Vaporshark and a cnc 1590g, on both devices the room temp is around 10° too high.
-
On profiles 1-8 it would be nice to be able to drag the tabs around to rearrange them. It is getting old entering all the info over and over.
Then to add to this, drag the tab off of escribe and onto the desktop, where it is saved with all settings and custom screens and curves. I then could open up another device and drag that custom profile into it.
Also need a show/hide checkbox. So if I only have 5 profiles, the device doesn't need to scroll through all 8. -
It would be nice if you would list version numbers and firmware version on the front page.
for example,
*** 2015-09-03 EScribe v 1.0.33***
https://www.dimensionengineering.com/software/UpdateES_2015-09-03.exe (10MB online installer)
https://www.dimensionengineering.com/software/SetupES_2015-09-03.exe (51MB standalone installer)
*** 2015-08-21 EScribe v 1.0.??***
*** 2015-08-21.sw-update***
https://www.dimensionengineering.com/software/SetupES_2015-08-21.exe -
Broken dna200 + rma = new dna200
-
Why do we have all the accuracy and the ability to make minute adjustments with this chip but preheat punch we have an arbitrary number 1-11? And why 1 - 11, most people would use 1-10.
If I want to set it to 50° below my set temp, what number do I pick?
I request to get rid of the slider and just type in the degree offset i want. -
Here's a pic of my Alpinetech 1590G+ using a Thunder Power 1350mAh and Mitec switch.
-
Reference stainless would be nice. Opus caps would be great for the project I'm working on.
It is a shame I will be putting YiHi buttons in my DNA200 mod.
Room Temp
in General Discussion
Posted
I have run case analyzer multiple times on the 1590G. On the Vaporshark i am using the preconfigured numbers.
While we are on the subject, anybody know what °F/A is?