I was trying to calibrate my DNA75 device, and after the calibration I have come up across a problem. Here's a run of what I have done. 1. Mod resistance calibration. Came out to be 0.004 -> uploaded 2. Battery analyzer. Fully charged HG2, soft cell cutoff at 2.5V, battery analysis at 30W -> saved and uploaded Now, after disconnecting from escribe and replacing the battery, 1. It first read the ohms, but started fluctuating. 2. I took off the atty and adjusted 510 (510 pin is adjustable by using screwdriver) 3. It is making solid connection, but the ohms read 0.01. 4. When I take off the atty, the ohms will still read 0.01. I can even fire the mod. Wattage will go up very slightly then say "Ohms too low" There's no short in the atomizer. Can someone help me diagnose this issue? I can send it back to modder, but the shipping cost is huge (overseas).