DNA60c wont connect to escribe ! Please Help

[Pigsy]

Hi all

I making my own mod have soldered everything where I believe it should be using a 2amp charging board for the dna60c, plugged it into escribe it detected the board then said no device connected. Have tried several USB cables but no difference, it connected one time started to up load the settings and stopped at 6% and wont go no further and escribe just has the spinning wheel I can't even Close escribe.

I'm using windows 10, Any help would be appreciated as I am gutted was the last thing to do to complete the build.

Have attached a pic below just incase someone can see something I've missed

Cheers Si

[Wayneo]

1 hour ago, Pigsy said:

...... it connected one time started to up load the settings and stopped at 6% and wont go no further and escribe just has the spinning wheel I can't even Close escribe.

Restart your PC and escribe. Use the cable that worked.

No image shown. Don't drag and drop, just choose and upload image (do not insert image). Is it the evolv USB-C board?

[dwcraig1]

It looks to be wired correctly to an Evolv C board.

Avoid using a USB hub.

[Pigsy]

Thankyou for your replies @Wayneo @dwcraig1 now ive calmed down and went searching the forum i read a post about escribe cant connect without a battery connected, the only thing i didnt try and low and behold she lives. Least i know my connections are good after resoldering everyone 😄