Replay Issue

[illogik]

I've been using replay for the last week or so since I got my hadron pro but today for some reason, it wont fire when I create a save. Instead it says check atty. I resample the atty and then it fires again but without replay as the previous save gets lost during the process. I can vape on it fine but as soon as I save a replay and try to vape with that I get the check atty warning again.

Any ideas?

Edited March 1, 2022 by illogik

[Wayneo]

Same coil as before (or all week) when it was working fine? 
Can you let that atty sit for 10-15 minutes, THEN do the resample, puff and save
 

[illogik]

Same coils yes. Do you mean remove the atty from the mod and leave it sit?

[Wayneo]

Doesn't matter really

[illogik]

Well in that case, it has been sat unused lots of times today because I have 3 other setups in use too so I'm not using that one all the time.

 

I have removed the tank anyway. The mod has been sat without a tank for almost 15 mins now.

[illogik]

Ok, I put the atty back on the mod, resampled. Had 1 puff and it showed the option to save. I had another puff (was going to save after the 2nd when it was a bit warmer) and the option to save isn't showing now. It just says 'ready' after all puffs.

[illogik]

Hmm, tried again after typing the above. Had one puff and the save option appeared. I saved and then tried again and it gives the check atty warning again.

[illogik]

I just tried my titan tank on there and it lets me save then replays without any errors. I don't get it.

[illogik]

Ok, I tried all 3 of the atty's I'm currently using with SS coils. Both my titan v2 and plus v2 work with replay fine but when I put the ragnar back on there, same error when I try to use replay.

Edited March 2, 2022 by illogik

[Wayneo]

Check your build that all your connections are tight and the coils glow evenly (you can do that on a different mod)

Check atty errors can be like finding a needle in a haystack. From dirty 510, to 510 threading, loose positive on the atty, loose coil, uneven heating and hotspots, etc. 

[illogik]

Hmm, might be easier just to rebuild with some new coils then...

 

Thanks Wayne!

[illogik]

Well I am completely puzzled now. I stripped down the ragnar. Wrapped new coils and put the deck on the dna mod to remove hotsepots etc before wicking, and I'm already getting the same check atty error. wtf

[Wayneo]

Did you check all those things I mentioned? The positive pin on the atty is tight, etc. In escribe, you can go to the bottom of the profile and run atomiser analyzer. It should show a relatively steady reading for your coil, or a slowly decreasing value if your coil is cooling down.

BTW, did you resample that new coil before using, or let it cool (after dry burn) and then resample? 

[illogik]

Yeah I resampled before firing.

Just checked the pin now and it wasn't exactly loose but wasn't tight either. I tightened it up a bit and it seems to be working ok now. It's letting me save and replay, so far.

[illogik]

Just tried some new cotton which I'm not liking so gonna change back. Will let you know if it still works in a bit once I've done that.

[illogik]

Well it seems to still be working fine. Thanks a lot for your help Wayne. Much appreciated 

[Wayneo]

Good news 🙌