67exec Posted July 4, 2017 Report Share Posted July 4, 2017 putting a dna 60 in a vapor flask clone, and I'm sure that I can just hook the B- and the GND together, but checking first. The daughter board was broken in the device when I got it, so it had to go by the wayside. Next question is, should I run a jumper from B- to GND, or run 2 separate wires from the solder tab on the 510? This mod uses the case as the B- Thanks in advance Link to comment Share on other sites More sharing options...
67exec Posted July 4, 2017 Author Report Share Posted July 4, 2017 going through pinout again, and noticed that B- and GND are connected internally Link to comment Share on other sites More sharing options...
VapingBad Posted July 4, 2017 Report Share Posted July 4, 2017 That's right, you don't need a jumper on the DNA board, but I prefer 2 wires to spread the current and lower the resistance. 1 Link to comment Share on other sites More sharing options...
67exec Posted July 5, 2017 Author Report Share Posted July 5, 2017 With 2 wires, can I run 20g-22g instead of 18g? Space is at a super premium w/o a daughter board Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now