Cell Soft Cutoff

[Kahless]

Hi,

I received my first DNA200 mod today the VTBox200 and read in the manual not to allow the cell's to go below 3.6V.  It has a 3c lipo 1800mAh 11.1V 35C in it.

The standard soft cell cut-off is 3.09V in the software but I have had to change it to 3.6 on my device due to the manual.

Does anyone have any idea if I can use the 3.09V or should I go with what it says?  It is effectively a 1500mAh battery if I set it to 3.6V (which some people have suspected it is on the internet, not that I believe everything I read on there but it does stack up with the physical size of the battery)

Anyone any idea's

Thanks in advance
Robert

[Brandon]

Hi Robert,
I think that may be a typo or just plain nonsense.  From the pictures I saw of the pack, it is a standard 3 cell Li-PO and an under load cut off of 3.09 should be fine.  3.2v would probably extend the batteries life a bit but 3.6v seems high.

[Kahless]

Hi Brandon. Thanks for the reply. When you say under load cut off is this the same as the soft cell cut off in escribe? Thanks Robert

[Brandon]

Yes, they are the same.

[Kahless]

Thanks Brandon.

[Douroguy]

Great info. thanks

[dion81@live.com]

I just bought the lava box. what it the lowest cutoff would yall recommend for maximum battery life and what type of battery does this box have lith or lifePo

[VapingBad]

Are you sure it is a LiFePo I thought they were LiPo, they operate at different voltages to LiPos and you need to get this right, but the default is fine for both 3.09 V for LiPo and 2.7 V for LiFePo.