VT200 wont fire..!!

[Milkweed]

My device is almost a year old and recently cant hold a charge for long. I was about to get a replacement battery but something happened yesterday night. After re-wicking my Mage RTA, put some juice in it and fired it up...that's when it happened. Screen went blank. For a moment, I thought it was a blown fuse but the screen came back on a minute later. And from then on, the mod would just restart whenever I fire. Screen would go blank and come back right on. Could it be just a bad battery? Cause I checked the fuse and it was still good. All the settings are gone too.

[VapingBad]

It could be a low/bad battery, I would look in device monitor, check all the cells.

[Milkweed]

I pretty much think so too. Battery is bloated quite bad. But would a bad cell show on escribe? Cause evrything looks normal there. I'm still getting a replacement battery though.

[Milkweed]

VapingBad said:

It could be a low/bad battery, I would look in device monitor, check all the cells.

How would I know if it's bad..?

[VapingBad]

I am no expert, but I would expect to see one or more cell at a low voltage and one or mores voltage sag excessively when you press fire, but if it's bloated I would just replace it anyway.

[Milkweed]

VapingBad said:

I am no expert, but I would expect to see one or more cell at a low voltage and one or mores voltage sag excessively when you press fire, but if it's bloated I would just replace it anyway.

Yeah...i'm still getting it replaced no matter. My only worry is if it still wont work with a new batt. I come from a place where evrything is almost impossible to get. But thanx for your input anyway.

[VapingBad]

If the fullymax 900 mAh Evolv sell will fit they do cheap international shipping, $19.99 + $5 anywhere in the world.

[Milkweed]

I'm sure they do but it wont get pass the checks here. I'm on my own. Still sourcing for a good rc batt locally that will fit.