lalemandrew

Thanks figured so but don't wanna screw up and how can I wire white connection to go out back of board instead of screen side

Where the battery goes into the board can I wire 2 wires with the orange adapter so I can swap batteries and make easier external charging

Thanks everyone I'll post results later

What's that

So I wired everything up with xt60 worked like a charm so now it's time to put in box so I find out it won't fit with the battery connectors so I cut them off and wire directly to the board finish everything now it Wont turn on I'm so frustrated I have been doing this for 4 months and have over $200 invested so what could be going on any help would help thanks and pray for me lol

So I wired everything up with xt60 worked like a charm so now it's time to put in box so I find out it won't fit with the battery connectors so I cut them off and wire directly to the board finish everything now it Wont turn on I'm so frustrated I have been doing this for 4 months and have over $200 invested so what could be going on any help would help thanks and pray for me lol

One of these work

What if I have a 2200 with 25c is that ok

How do I know if the battery will work I know it has to be a Lipo 3s 11.1v but what else is important

WHat A is the battery supposed to supply to boarx

What's a better brand

So this battery is good

What does the discharge need to be on a battery to properly run the DNA 200 board and how do I figure out a battery discharge rate? Will this work

How can I wire a momentary switch with an led light in it to only light when hitting button I seen it done where u run it from the 510 but I'm worried if I'm vaping 100w I'm technically not cuz I'm drawing power for led does anyone know what to do and is there a good video?

So I can run the ground to the 510 connector off the board