bgarren

it Is deeper, I have it somewhere. ill post it tomorrow

GOT IT , that is weird, with internet explorer it only downloads as a zip automatically. I changed to chrome and it works fine. Maybe there is a bug in internet explorer

yes, if I download it, it only saves as a zip file, and shows up as html file. It is strange. EDIT: with google chrome it downloads as it should. internet explorer 10 is downloading as a zip for some reason, without the ability to properly extract the file.

Can you not upload it as a regular Escribe theme? unzipping doesn't seem to be cooperating

Not really for one profile. Try a greater preheat punch. They would have to recalibrate the entire chip to go above or below the temp thresholds in place. The issue is the temperature is at a threshold most materials are safest and most efficient at. Remember at the start 450 degrees was a setting to avoid dry hits at the burning point of cotton. Try a different wire for a warmer vape, such as sweet spot ti, it will probably be the warmest with one of the lowest k values or heat absorption to size ratio

A copper shorting pin, (510 threaded with a little bulge on top to unscrew/screw it in) and observing resistance change while fully compressed, and what happens as you extrude it. A good reading can be taken as the shorting pin is inserted fully, you just want to make sure it doesn't vary too much while doing so.

^^And yes I had several dna40 issues as well, but have 3 devices with no issues and I'm just going to ride them out.

After sending mine off once, after a month of waiting, one of the inductors has now fallen off of the board. Back to dna40. I was super happy with it once again then more issues.