No compatible USB Devices are connected.

[Exro]

Hello guys i recently ordered a DNA100C Board to use in a Project of mine which is to Design and 3D print a mod.

Ok today the board arrived, i plugged in the screen and connected it to my PC (Back then WIndows 10) the red indicator LED lights up and the screen flashed on for like 100ms, it showed proper stuff from what i could see and the PC made the USB device connected sound. In Escribe i am at the screen where it says to continue please connect a device, during the time where the screen flashed it also detected the board but it immediatly disconnected. I tried multiple things and in the end even reinstalled windows to windows 11 because my old windows installation was pretty bad. Ok then i also tried it on my macbook same behavior screen flashes on for a few ms and pc recognizes it and iimmediiatly disconnects again. Then i installed windows 11, now it wont even flash the screen or connect for a short time, now it just shows i need to connect a device. I tried multiple cables aswell and since it did find the mod on windows 10 and my macbook i think i definitly got a data cable i am using- Welll i am trying to get back to where it atleast connects for a second on my windows 11 installation now, in the meantime can anybody help me resolve this issue?

[Wayneo]

The board must also be connected to a battery for escribe to recognize it.

[Exro]

Oh wow havent thought about that i thought i could still configure it without batteries attached, sry about that then