Can the DNA60c handle more than 10A?

[3akhar]

Hello everyone!
Lately, I've been constantly encountering board blocking and the "Too Hot" message on the DNA60 (Kil-Lite Mod). I read on the forum that this is a common problem for DNA60 and that it overheats at a current of more than 10A.

Is this problem fixed in DNA60c?
I want to use low resistance thermal materials (SS, NiFe) in Replay mode.

[Wayneo]

4 hours ago, 3akhar said:

"Too Hot" message on the DNA60 (Kil-Lite Mod). I read on the forum that this is a common problem for DNA60 and that it overheats at a current of more than 10A.

Really? On THIS forum? I think you are mistaken, or show me.

[3akhar]

43 minutes ago, Wayneo said:

Really? On THIS forum? I think you are mistaken, or show me.

 

[Wayneo]

One (1) post, 7 years old for a dual battery DNA60, vaped at 50-60 watts does NOT make it common.

Edit: In my signature line, see that link 'Help Desk', click on that, you'll be talking directly to Evolv. 

[3akhar]

Just now, Wayneo said:

One (1) post, 7 years old for a dual battery DNA60, vaped at 50-60 watts does NOT make it common.

I tested it in my device (Kil-Lite DNA60). Really, the board raise the message "Too Hot" while I vape on 10+ amps. I tested it on different coils. If the amperage is below 10A, then everything is fine. Above - overheating and the message "Too hot". The board is blocked and does not allow vaping.

[Wayneo]

In my signature line, see that link 'Help Desk', click on that, you'll be talking directly to Evolv.