CoxyofNewp Posted March 8, 2021 Report Share Posted March 8, 2021 (edited) Hi Guys/Girls.. One of my DNA 75c mods needed a new screen, but the ribbon mounting point latch was broken in process (that's the little flip over plastic part that holds ribbon in place). I was wondering, can I replace the whole pin connector (seen one that I ( think will do the job on Aliexpress ) Or can I solder the ribbon direct to contact points. Think it's possible, but just looking to see if anyone got any advise first.. Many thanks Edited March 8, 2021 by CoxyofNewp Link to comment Share on other sites More sharing options...
Wayneo Posted March 10, 2021 Report Share Posted March 10, 2021 Here are the specs on the connector you need for the 75C. Amphenol FCI SFVL 0.5mm Pitch 8 Way Right Angle SMT Male FPC Connector, ZIF Bottom Contact Mfr. Part No. 59453-081110EDHLF 1 Link to comment Share on other sites More sharing options...
CoxyofNewp Posted March 12, 2021 Author Report Share Posted March 12, 2021 Many Thanks. I've ordered a pack of 10 for a few quid.. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now