My N1 250C

[KMac]

Well a few are showing theirs off so here is mine. 

[Ryan Brooks]

Have you had any initial battery problems after getting all together?

[KMac]

None I did the all the calibrations  ie the battery analyzer and case analyzer. 

Replay doesn't seem to like my Steam Crave Titan no matter what build I use but using a Kylin it's working flawless. 

[Ryan Brooks]

I see.. Which battery are you using in your build?

[awsum140]

I just built an N1, too.  What size battery did you use?  Mine is a 2200mah, 4S, NanoTech.  

Edited April 24, 2018 by awsum140

[Ryan Brooks]

31 minutes ago, KMac said:

None I did the all the calibrations  ie the battery analyzer and case analyzer. 

Replay doesn't seem to like my Steam Crave Titan no matter what build I use but using a Kylin it's working flawless. 

I can't do any of the calibrations, since the battery won't charge....

[KMac]

Are you using a 3S or a 4S? I've used a 3S for a week or so while waiting on the 4S to arrive just need to switch the config in Escribe but no issues at all for me.

[Ryan Brooks]

I"m using a 3s, I switched the config in the Escribe, and I see voltage coming from the USB, but not charging the battery.

[KMac]

on the board did you jumper the the last connector pin 4 either back to 3 or to B+? do you see each cell voltage in device monitor? when I was ruining it in 3S I just jumped it to the B+

[Ryan Brooks]

Hm, I didn't run a jumper wire to the fourth pin, I didn't think I needed to worry about the fourth pin... I suppose that's what I get for not checking a wiring diagram. Now, I'll have to try and undo the JB weld I used to hold in the chip holder...

[Ryan Brooks]

Well, I pulled it apart, and soldered a jumper wire from 4 to B+, but it's still not charging through the USB.

[Spector NS5 RD]

@Ryan Brooks Can you post a screenshot of Device Monitor with all of the battey options boxes ticked? An you are positive you have "3-cell" selected in EScribe and uploaded to the device? I would re-go over your battery wiring/soldering to the board, as well; balance tap connections and all.

[Ryan Brooks]

I'd post pictures, but I got irritated and pulled it all apart and resoldered it, but I did have everything soldered up correctly.