Balancer Resistor missing

[LIK Mods]

Hi, get a new DNA200 Board (new and unused). Use it with an 3s Lipo.

The Display only shows check Battery and escribe tell me cell 1 is only at 1,7V.

The Lipo is definitly ok (works well with an other DNA Board).

I checked the board and realized that there is one resistor missing (marked on the attached picture).

2 Questions:

- what kind of resistor and size

- is this the fault or could there be an other problem that it shows 1 cell 1,7v

[Spector NS5 RD]

Would the cost of shipping the board back to Evolv for replacement be too costly?  You know Evolv will replace the board, free, under warranty. You only pay shipping one way.

I don't have a board laying around to check for you. You can measure the remaining 3 resistors, individually, with a DMM to find the resistance. The remaining 3 should measure the same.                   My best GUESS for the missing SMD thin film resistor would be ( SIZE - 0402 or 0603) (RESISTANCE - 47 OHMS)

[LIK Mods]

vor 3 Stunden schrieb ChunkyButt200:

You only pay shipping one way.

From germany to usa not so cheap, and if its only the resistor, its no problem, its a 100ohm but dont know the size, realy tiny, only have a little bit bigger ones

[Spector NS5 RD]

 

5 hours ago, LIK Mods said:

From germany to usa not so cheap, and if its only the resistor, its no problem, its a 100ohm but dont know the size, realy tiny, only have a little bit bigger ones

I found an old board and measured the size and resistance.         resistor size - 0402   /  100 ohms

https://www.mouser.com/ProductDetail/TE-Connectivity-Holsworthy/RN73C1E100RBTG?qs=sGAEpiMZZMu61qfTUdNhGwtsVGeGBhoIhlYypu0mXVQ%3d

OR

https://www.digikey.com/product-detail/en/yageo/RT0402DRE07100RL/311-2216-1-ND/6128635

[LIK Mods]

much thanks for the answers, will try to repair it

 

[LIK Mods]

thanks for the answers, will send it back to evolv, seems that the solder pads ripped off with the resistor,  thread can be closed