Boomer35 Posted June 19, 2017 Report Share Posted June 19, 2017 Any wiring diagrams for 2 cell 200/250 board balance charging? I've done lipos but never the 2 cell. Link to comment Share on other sites More sharing options...
Wayneo Posted June 19, 2017 Report Share Posted June 19, 2017 Sorta like this one from dripp3d.com 2 Link to comment Share on other sites More sharing options...
Boomer35 Posted June 19, 2017 Author Report Share Posted June 19, 2017 Thanks! I'm using a small 3d printed enclosure so would it be best to bridge the wires to reduce clutter and keep it clean? @Wayneo Link to comment Share on other sites More sharing options...
Nick Posted June 19, 2017 Report Share Posted June 19, 2017 9 hours ago, Boomer35 said: Thanks! I'm using a small 3d printed enclosure so would it be best to bridge the wires to reduce clutter and keep it clean? @Wayneo You can, but the proper way to do it is to run separate wires for pins G 1 2 3 as to avoid voltage drop while firing due to tapping off the main power connections. Separate wires will ensure accurate readings. 2 Link to comment Share on other sites More sharing options...
Boomer35 Posted June 23, 2017 Author Report Share Posted June 23, 2017 So I my G port off my jst connector hooked into the bridge that connects my positive and negative? Or does it matter being that the 2 are bridged together to create the series connection? I have a couple different diagrams and one does it one way and this one is showing me different? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now