antyac2108 Posted July 22, 2015 Author Report Share Posted July 22, 2015 Thank you I just pm you my address Link to comment Share on other sites More sharing options...
John Posted July 22, 2015 Report Share Posted July 22, 2015 You should have a replacement board arrive Friday, and a UPS label to send your existing one back so we can see where it is getting the fire signal from. Link to comment Share on other sites More sharing options...
antyac2108 Posted July 22, 2015 Author Report Share Posted July 22, 2015 Ok much appreciated. Link to comment Share on other sites More sharing options...
John Posted July 22, 2015 Report Share Posted July 22, 2015 Actually, before you send it back (your new one is already on the way, but if we get this figured out and you end up with two, merry christmas) try pulling the output wire off the board and see if it still auto-fires. The large exposed silver via you circled won't cause the board to auto-fire, but if your output wire was shorted to the smaller green-covered via next to it, that absolutely COULD cause what you're seeing. Link to comment Share on other sites More sharing options...
sgtmonty Posted July 28, 2015 Report Share Posted July 28, 2015 @antyac2108 did you figure out what was happening with your board? I have the same or similar issue, and am at a loss for an explanation. I am going to try all the things suggested on this thread and hopefully I figure it out. Link to comment Share on other sites More sharing options...
antyac2108 Posted July 28, 2015 Author Report Share Posted July 28, 2015 I think it's the tact switch but I sent mine back to evolv I would private message John. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now