Mod resistance issue?

[fallenmind]

I was wondering if anyone else was experiencing this anomaly when using Atomizer Analyzer. I took a dripper and put a solid copper wire into the positive and negative post in an attempt to read my mod resistance. However, as I was screwing down into my 510, I watched the resistance drop until it reached 0.012 ohms, then I got a question mark. It would seem that my chip will not go lower than .012 without losing the resistance reading. Will the dna outputs not take a dead short? I did enter this value in my mod resistance and although its vaping fine, I was just curious as to this issue and if anyone else has experienced this. Any help I can get on this topic would be greatly appreciated.

[VapingBad]

Sounds like you already have a value set for mod resistance and it is measuring a too low value, you should zero it before measuring.

[fallenmind]

That was it! Thank you very much and have a Happy New Year!