intex009 Posted October 29, 2016 Author Report Share Posted October 29, 2016 is graph ok for my build 26g surgical grade 1 titanium wire ID about 3.1mm 7 wraps, dual coil. i have adjusted my resistance based on the atomizer analyzer of escribe. Link to comment Share on other sites More sharing options...
VapingBad Posted October 29, 2016 Report Share Posted October 29, 2016 You shouldn't lock the resistance. Link to comment Share on other sites More sharing options...
intex009 Posted October 29, 2016 Author Report Share Posted October 29, 2016 is there a difference between locked and unlocked resistance? Link to comment Share on other sites More sharing options...
VapingBad Posted October 29, 2016 Report Share Posted October 29, 2016 Yes, very much so, if you lock the ohms you stop the board being able to refine the base/cold resistance by monitoring the coils temp against room temp while they cool, they do this for up to half an hour after going into idle to get the most accurate resistance reading possible. Link to comment Share on other sites More sharing options...
intex009 Posted October 29, 2016 Author Report Share Posted October 29, 2016 noted on that, thanks!for my pre heat power,punch and time is already good? Link to comment Share on other sites More sharing options...
VapingBad Posted October 29, 2016 Report Share Posted October 29, 2016 Preheat is a matter of personal preference, you could certainly increase the power and the punch if you want it to get to temp faster. (punch is how close it gets to temp before stopping preheat, IIRC 0 = -160 F, 11 = -10 F) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now