Markyt123 Posted December 17, 2016 Author Report Share Posted December 17, 2016 I have a question which might be dim. I've run wire wizard with the coil spec I've built. The ohms generated is .6 on wire wizard I've installed 2 coils which reads .31 on my DNA 250. My question is; is the .6 ohm csv I've taken from wire wizard ok to install onto escribe even though with 2 coils the mod reads .3. Furthermore, does it make that much difference from the standard ss316 profile already installed? Link to comment Share on other sites More sharing options...
Spector NS5 RD Posted December 19, 2016 Report Share Posted December 19, 2016 it should be fine to use. there might be little to difference in the vape from either profile. whatever you like best, use. Link to comment Share on other sites More sharing options...
Markyt123 Posted December 19, 2016 Author Report Share Posted December 19, 2016 Cheers for the response. Link to comment Share on other sites More sharing options...
Dampmaskin Posted December 20, 2016 Report Share Posted December 20, 2016 Was the 0.6 Ohm figure for a single coil? If so, it makes sense that a dual coil will read close to 0.3 Ohm.In any case, the TCR will be unaffected. Link to comment Share on other sites More sharing options...
Markyt123 Posted December 20, 2016 Author Report Share Posted December 20, 2016 Excellent! Thanks for the response. Learning as I go! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now