This has got me confused.....

[bluntmoment]

I have built a mod using the DNA250 screen. everything came out pretty good, solder points look good etc. I have charged this mod once since I have built it. It charged just fine w/o any issues. Now this morning I was at 60% so I figured I would charge it at work. When I first plugged in the usb charger the lightning bolt came on but it started flashing, I have never seen this before.  Since then the flashing has stopped however it hasn't charged at all, still on 60% and its been around 40 mins on the charger. I am using a Turnigy Graphene 3000mAh. I have all the settings changed via escribe. The others I have built using this same set up have worked just fine. Now this one is giving me fits lol

[dwcraig1]

What does voltages does EScribe say the cells are, a screen of device monitor would be helpful.

[bluntmoment]

for some reason I cannot get a screen shot of device monitor. But I did notice that the Wh keep changing itself from what I had it set up as which is 33.3wh to 19.79wh.
The cells are 3.86v, 3.87v. 3.87v., and the room temp states -19.99F, board temp -39.99F

[bluntmoment]

 

[dwcraig1]

Well the room/board temp is way off. It must think it's too cold to safely charge. Probably you should open a ticket with Evolv.