[Reading ohms too low]

Dear Mr.James

Below my test results on Therion DNA75C:

Device powered up by fire button

I=GET OFFSET [RESULT=0.097A    ]
V=GET OFFSET [RESULT=0.034V    ]

R=SAMPLE OFFSETS
I=GET OFFSET [RESULT=0.090A]
V=GET OFFSET [RESULT=0.030A]
R=SAMPLE OFFSETS
I=GET OFFSET [RESULT=0.098A]
V=GET OFFSET [RESULT=0.034V]
R=SAMPLE OFFSETS
I=GET OFFSET [RESULT=0.090A]
V=GET OFFSET [RESULT=0.030A]
R=SAMPLE OFFSETS
I=GET OFFSET [RESULT=0.098A]
V=GET OFFSET [RESULT=0.035V]

SS316 coil measured on other device = 0,64 ohm
On therion 75C=   0,5998 ohm
delta=0,042 ohm
room temp 27 degc \ same result on mod

BR , Francesco

[Reading ohms too low]

15 ore fa, John ha scritto:

If it is reading stably, then we can now chase down the missing .04 ohms.

Hello

Exacly same delta here with Therion 75C , it reads minus 0.04 ohms on cold coil .

With last SP23 , after performing case analyzer , at first glance I have much better results (after manually playing with Case static Temp rise parameter , which was not calculated by analyzer). Thanks !

regards , Francesco

[Reading ohms too low]

hello attached my results on Therion DNA75C

Sorry if this is a stupid question (I'm new on DNA stuff) but do have i to calculate the static delta temp manually ?

Regards

Francesco

[Problems with Battery Meter]

Thank you Mr.James !

[Early Firmware and EScribe Suite Discussion Thread]

Il 15/7/2017 in 01:52 , Droopydroors ha scritto:

Dna75c still running cold on newest beta firmware.  Please address the issue. It seems to be a pretty wide spread issue in most forums.

Yes I see same problem

[Problems with Battery Meter]

Hello

I'm definitely not an expert owning my first dna mod from a week , anyway with latest beta sp I had a problem with Battery pack volt reading stuck around at 54% , downgrading to last official one it went ok.

Best regards

Francesco

ps : cold ohm reading is still too low on both service packs