john_99205

Make sure that your mod is set to the same profile as the one you set up in eScribe, you have to set the profile manually on the mod (press Up and Down button to lock your Power; double click Up button (or Down button) and use Up or Down buttons to go to the right profile; don't forget to confirm the profile by pressing the Fire button. It was one of the things that confused me when I got my first DNA200. I have been using SSV Ti wire for several months, and everything has worked perfectly (until I tried the 0.4mm CSV file that they posted last week), Ari had sent the 0.5 CSV file to me when I first received my SSV wire).

1.0.35.2 is working well: go with it! It would be nice to be able to increase the Celsius degrees by one degree increments on the mod.

In that case your mod is sending 200w in pre-heat to you coils which may be the problem. Also If you are using TC, it will be set to Ni200 and not Ti, which has a different temperature coefficient. I would use non TC at about 30w until you can connect your mod to eScribe.

Looking at your photo, your coils seem to be heating unevenly and your cotton is definitely burned. Maybe you should lower your temperature, lower your pre-heat power, lower your watts. Also make sure that your mod is in the right profile (1-8) as the profile in eScribe, that you made your settings; it is a mistake that I once made. Also lock your atomizer's resistance with Escribe's resistance reading (not a seprerate ohm meter). Lastly look at the "real time analyser" when you vape, and fine-tune your settings.