davidb07
-
Posts
3 -
Joined
-
Last visited
Never
davidb07's Achievements
New Member (1/3)
0
Reputation
-
What had happened to all the software and firmware links on page 1? Gone.
-
Boo non-Evolv RX200s. I hope Evolv gets the injunction and steep licensing fees when its all over.
-
Resistance still climbs while it's supposed to be locked?
davidb07 replied to p8ntballa9362's topic in General Discussion
Atty Lock only works in Temperature Protection mode, with Ni200 wire (or possibly Ti, if you set it up in Escribe properly; Steam Engine could assist with the values). If you can apply Atty Lock, you are in Temp Protect mode and you need to lock the device, hold the up and down buttons until you can change temp value and then press "UP" until the value displayed goes past 600 and to OFF. Once temp protect is "OFF", you can set the wattage and the output of the device won't change. At that point, it's a regulated Mod without Temp Protect and without Atty Lock.