in device monitor cell 1 shows 0V, cell2 5.72 and cell 3 4.19 all batteries are fully charged outside and multimeter shows 4.19v mod is not working for vaping but communicates with escribe fine. tested wires at board side where balance connectors are soldered and multimeter shows correct voltage as well as total pack(between gnd and b+) so its not wiring mod shows total pack voltage 9.4 V. if i switch it to power supply mode it actualy fires. cant tell if it fires at full power cos im afraid to test it at high wattage. on battery mode it wont stay on unless connected to usb. pressing fire button without usb plugged it shows check battery and turns off.