[Turnigy nano-tech 2200mah 4S 25~50C .csv]

Here's one for the 1800mah

Turnigy nano-tech 1800mah 4S 25_50C.csv

[DNA250 without PCB buttons]

So far those have held up for our customers.

Except the paint on them. 😂

[DNA250 without PCB buttons]

Thanks for the infos.

I have several S-body DNA75s also with the same defective daughter board I wanted to reuse. 

 

[DNA250 without PCB buttons]

I understand, so I just need to bridge the Down and Fire button like in picture 1 to use 3x external buttons correct?

[DNA250 without PCB buttons]

If you look at the first pic, you can see the Fire and Down button bridges. The Up button wasn't bridged.

I'm only interested in the UP/Down/Fire buttons, not the Power/Battery bridges for 2S/3S configurations. Why does that effect the Up button?

[DNA250 without PCB buttons]

Thanks for the reply.

I kinda figured they are needed, but the UP button didn't have a bridge.

That confuses me as to if it's really needed or not.

[Onboard LED]

Indeed it is. The best looking LED on a box I've found is the VapeCige Creator DNA75C.

It looks like it's using a light pipe.

[Onboard LED]

I found that epoxy and ca glue both diffuse the light quite a bit.

Most DNA75Cs seem to have a tiny 1 mm hole, but I have yet to 

open one and look how they did it.

[DNA250 without PCB buttons]

I have a Vapedroid by S-body with a defective daughter board.

S-body has mutilated the poor DNA board with terrible soldering, 2 daughter boards

and removing the up/down/power buttons. The fire and down button had a bridge.

I would like to know if the bridges are needed to use external buttons when removing the 

onboard buttons.

Chip has been cleaned and is ready to be built into a proper mod.

[Graphene LiPo batteries are on the market. Anyone know anything about them?]

If you are planning on charging via the USB port it does not matter the discharge rating of the LiPo as it is limited to 2A.

I find the Graphenes hit harder in PWM mods but give no real advantage with the DNA boards.

Take a look at the Turnigy Nano Tech series, they may have some LiPos with more mAh in the size you are looking for at a  better price.

https://hobbyking.com/en_us/lipo.html?config=54&

 

[Onboard LED]

On the red box in the attached picture, where the onboard fire button/LED rest I'd like to drill a hole 

to bring out the onboard LED.

Has anyone any proper suggestions to what LED light pipes / plugs to use?

 

[TC bug]

I see, makes sense. I had built a .23 and it was a strange sight to see.

[TC bug]

I had a profile with ohms locked to 0.56, changed coils and forgot to unlock/set the coils properly to the new ohm value. When I went to hold down and fire, I didn't lock the fire and it fired shortly showing 33554 degrees celsius. Sorry for the terrible picture attached, but I don't want to try reproducing it as a safety precaution. Using firmware 2016-02-29 EScribe 1.0.42

[Early Firmware and EScribe Suite Discussion Thread]

Thanks for your time and efforts.
No issues here, runs likeaboss.