tux

Wayneo, many thanks for your reply. I didn't know this interesting tool. Below you can find an approximate calculation of my current setup: I assume that it shouldn't be that hot. Any comments are highly appreciated!

Hi all! I have a 4 year experience with mods and repairable atties but I am totally new to TC. I bought a vt75 nano, ensured that it's internal screws are ok, I cleaned the poles and configured it with escribe. I don't have a way to measure the internal resistance at the moment so i put an approx value (0.004). I have also run the case analyzer under stable temperature room conditions. I decided to start with dicodes nife30, because I wanted to be sure about the TCR value of the wire I am using (320). I created two materials. One with the TCR value and one with a TFR csv from steam engine (Resistherm option). My coil is approx 8-9 open turns with a 2.5 internal diameter (I also tested with 3mm with no change in performance). I checked the stability of the resistance with the atomizer analyzer and it seems that it's sable as the changes are on the third digit (0.476 - 0.478 for example). I have been doing my tests for the last three days with two rebuildables (tilemachos V2 plus and modded kayfun 4 with a changed pole to have stable resistance). I set the max power at 17 Watt, without preheat and the temperature at 465F which was suggested by dani users. With all these settings vaping is horrible. In order to get the same vaping experience with kanthal/16 Watt, I have to raise the temperature to 520F which I believe it's not normal. Do you have any suggestion on my issue? Is it normal to have to go to these temperatures to get what I am used to with kanthal? Many thanks in advance!