Nykademos

I have two weeks b4 my shapeways stuff comes, but the 1250 wedges in between the mount points and will rest barely against the 510 pin mounted as close to the post as the nut can be, make sure its a shallow mitec, it also has to be mounted close to the post for the board to fit, there is just enough space to wedge the battery in the left over space, I only have 16mm for the board. it needs 13-14mm at its widest point (the balance connector), I worry that with the plug connected, I might be short 2mm but I can always wire the balance connector away from the board if i need too, which is likely. I may also have to wire the fire switch direct, but I'll have the parts to play with and see whats what. I am one of the least likely ppl on earth to post a pic, I dont do facebook or anything else. But I was thinking about doing a virgin build video for the youtube. lets face it, chances are I will screw everything up, but at least I'll learn something. I'll keep you up to date so we all can learn from my mistakes.

I am building ati 1590g+ with this battery http://www.hobbyking.com/hobbyking/store/__76912__Turnigy_1250mAh_3S_30C_Lipo_Pack_Long_.html -- 90x30x20mm-30c. Got a mitec fire switch and some 3d printed nickle steel buttons for up/down. I tried to fit this battery in the regular 1590g, too thick gotta use the g+ and the lid flanges close with the battery all the way against the edge, I am going for clean build. I even got a 2 pin jst clip to mount to the board for my fire switch, this battery also comes wired with xt30 and will leave me space enough for a clean build with removable battery (I got 2 of these). Just waiting on shapeways for my buttons and board/screen mount from Mamu. I'm going to use hex screws countersunk in the face to mount the board, sanding the box to a high shine. BTW, this is my first build, so wish me luck!