kiyong Posted January 24 Report Share Posted January 24 The Ohm value appears high in boro devices using DNA 80c. For example, when rebuilding, it was 0.6Ohm, but when connected to the boro device, it is displayed as over 0.7Ohm. Is this a characteristic of dna 80c? Link to comment Share on other sites More sharing options...
dwcraig1 Posted January 24 Report Share Posted January 24 I'm going to say no it is not characteristic of a DNA80C board. The board will due a pretty good job of reading the correct load put upon it. This doesn't mean the value will be correct though as there are a few connections made between the board and coil and any one of those can throw the whole value off. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now